EMITEVER LED Strip Connectors, 12 Packs LED Tape Light Connector 2 Pin Solderless Tighten Screw Transparent Tape to Tape Connectors for 5V 12V 24V 8mm Width LED Strip Lights

Wide Compatibility - 2Pin 8mm LED strip light connectors are suitable for most 5V 12V 24V SMD LED Tape Lights or COB LED Strip Lights. Connect strip light end-to-end for long runs. Not designed for RGB LED strip lighting.

Seamless and Quick Setup - Screw-down connector for easy installation, easy to disassemble, no need to weld, makes the light strip more firmly installed. Just plug the strip into the connector and tighten the screw with a screwdriver. (screwdriver not included).

​Tackle Poor Connections - Say goodbye to the annoyance of flickering strip lights. The unique transparent connector design will not affect the color of the strip light. and makes it easier to completely fix the strip light on the metal sheet of the connector, fix poor connections, and integrate with the strip light as much as possible. enhancing project reliability and efficiency.

3MM adhesive backing- It also contains 12pcs of 3MM adhesive backing, which can stick the connector on the wall to avoid the risk of pulling off the light strip.

​Quality Assurance - We stand by our product's quality. If you're not entirely satisfied, we offer a complete refund. If you have any questions about how to connect, you can refer to the instructions in the package or contact us at any time.

 
ATTENTION: Ensure your led strip light PCB Width and Waterproof Rate matches with connector prior to purchase.
 
Only suitable for 8mm width SMD2835/5050/5060 led strip light and 8mm width COB led strip light.

Only suitable for IP20/IP44 non-waterproof and IP65 silicone glued waterproof.

Not suitable for 8mm width SMD2835/5050 RGB color changeable led strip light.
 
How to use this 8mm 2 PIN led connector？
 
1. Cut your led strip light at indicated area.
2. Take off 5mm off the back of the strip light.
3. Loosen and insert led strip light.
4. Screw down, make sure it is tight and pay close attention to + - polarity markers.
5. Power on the led driver to check if the light turns on (if not tighten the screws).
6. Fix this led connector with tape on button.

 
Width：8mm
Working Voltage: 5 - 24VDC
Max Amperage: 5V-4A 12V - 6A / 24V - 6A
Included Accessories: 3M adhesive tape and Manual.
Working Environment: Indoor
Ambient Temperature: -20℃ - 50℃
Material: Polycarbonate
Color: Transparent